FOR BUSINESS
Base oil SN 650
General features
The product is obtained from the crude oil vacuum fraction, selectively refined out of solvents, dewaxed and hydro-refined. Those processes enable receiving the desired properties of the final product, such as lack of low-index substances, better colour, good low-temperature and thermo-oxidation properties. Base oil SN 650 is intended for use in lubricants production.
Application
Base oils are used for the production of lubricating oils, oil products, greases, plasticizers.
Physical and chemical properties
ZN-ORLEN
| Properties | Unit | Value |
|---|---|---|
| Density 15°C | g/cm3 | MARK |
| Kinematic viscosity at 40°C | mm2 /s | min. 135 |
| Kinematic viscosity at 100°C | mm2 /s | 13,0-16,2 |
| Viscosity Index, min | | 87 |
| Pour point | °C | max. -9 |
| Flash point open cup | °C | min. 240 |
| Structural viscosity at (-15°C) | mPa.s, max | - |
| Coking residue (Conradson) | %(m/m) | max. 0,1 |
| Ash residue | %(m/m) | max. 0,01 |
| Basic number | mg KOH/g | max. 0,05 |
| Volatiles content (Noack) | %(m/m) | - |
| Colour | | max. 3,5 |
| Appearance at 20 ± 5 °C | visually | |
| Demulsibility time to oil/water emulsion separation | ||
| at 54 °C | | 30 |
| at 82 °C | ||
| Refractive index | nD20 | 1,483 – 1,4990 |
| Oil distillation under reduced pressure: | ||
| till 250ºC distills | %V/V | 0 |
| 5% distills till temp. | ºC | 440 |
| Sulphur content % | (m/m) | 0,89 |
| The above values of physicochemical parameters are typical values. Actual values are indicated on the quality certificates attached to each product lot. |
||
Commercial contact
sales representative:
Piotr Bugajski
Phone:
+48 242 010 717
+48 603 950 885
E-mail:
SALES REPRESENTATIVE:
Maciej Niechaj
Phone:
+48 242 010 139
+48 665 444 843
E-mail: